Pulling of Signature Information

[kronos]

Is there a way to pull of Each Signature Data, so that when you microcontroller powers up it loads the information to the pixy on what to look for?

If this is possible one could then swap out the pixy and not worry about reprogramming it, I know it’s not hard to reprogram, but if I have one in use say at a museum exhibit, 2 years from now, if one needs to be replaced for whatever reason, they would be able to just swap it out and power cycle the microcontroller.

[srobins1]

Hi Michael,

Currently, it is not possible to load signature data from Pixy on to a microcontroller. This seems to be a highly requested feature, so we’ve been considering adding something along these lines to the library.

Thanks for including your use case, its always good to hear of different ways people are using Pixy.

Scott